Swingarm Related Parts Inspection - Suzuki Intruder VZ1500 Service Manual

2C-9 Rear Suspension:
Installation
CAUTION
!
The removed bearings and cushion seals
must be replaced with new ones.
1) Press the bearings into the cushion lever with the
special tool as shown in the rear suspension
assembly construction. Refer to "Rear Suspension
Assembly Construction (Page 2C-2)".
NOTE
When installing the bearing, stamped mark
on the bearing must face outside.
Special tool
(A): 09924–84510 (Bearing installer set)
(B): 09941–34513 (Steering race installer)
(B)
2) Install the cushion lever seal with the special tool.
Special tool
(C): 09913–70210 (Bearing installer set)
3) Install the bearings (1) and (2) with the special tool.
4) Apply grease to the bearings and cushion lever seal.
(A)
I940H1230026-01

Swingarm Related Parts Inspection

Refer to "Swingarm Assembly Removal and Installation
(Page 2C-3)".
(C)
Spacers
1) Remove the spacers from the frame.
2) Inspect the spacers for wear and damage. If any
I940H1230027-01
Special tool
(C): 09924–84521 (Bearing installer set)
1
(C)
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
defects are found, replace the spacers with new
ones.
2
(C)
I940H1230029-01
I940H1230041-01
B940H22306012
I940H1230030-01