Steering Tension Adjustment - Suzuki Intruder VZ1500 Service Manual

4) Remove the steering stem upper and lower bearing
races using the special tools.
Special tool
(A): 09941–54911 (Bearing outer race
remover)
(B): 09941–74911 (Steering bearing
installer)
(B)
(A)
Installation
Install the steering stem bearings in the reverse order of
removal. Pay attention to the following points:
CAUTION
!
The removed bearings and races should be
replaced with new ones.
Outer race
• Press in the upper and lower outer races using the
special tool.
Special tool
(A): 09941–34513 (Steering race installer)
I649G1620034-03
(A)
I649G1620035-03
Inner race
• Press in the lower inner race using the special tool
and install the bearing.
Special tool
(A): 09941–74911 (Steering bearing installer)
(A)
• Install the steering. Refer to "Steering Removal and
Installation (Page 6B-4)".

Steering Tension Adjustment

Check the steering movement in the following
procedures:
1) By supporting the motorcycle with a jack, lift the front
wheel until it is off the floor 20 – 30 mm (0.8 – 1.2 in).
2) Check to make sure that the cables and wire
harnesses are properly routed.
3) With the front wheel in the straight ahead state, hitch
the spring scale (special tool) on one handlebar grip
end as shown in the figure and read the graduation
when the handlebars start moving.
Initial force
200 – 500 grams
Special tool
(A): 09940–92720 (Spring scale)
(A)
Steering / Handlebar:
I649G1620036-03
B940H26206009
I649G1620040-02
6B-8