Table of Contents
Advertisement
1D-13 Engine Mechanical:
5) Remove the clamp and disconnect the fuel injector
couplers (4).
4
6) Loosen the throttle body clamp screws.
7) Disconnect the throttle cables from the throttle body
and remove the throttle body assembly.
CAUTION
!
After disconnecting the throttle cables, do
not snap the throttle valve from the open to
full close. It may cause damage to the throttle
valve and throttle body.
8) Disconnect the EVAP hoses (5). (For E-33)
4
I940H1140025-02
Installation
Install the throttle body in the reverse order of removal.
Pay attention to the following points:
• Connect the throttle pulling cable (1) and throttle
returning cable (2) to the throttle body.
I940H1140026-01
• Tighten the throttle body clamp screws. Refer to
"Throttle Body Construction (Page 1D-10)".
• Loosen each throttle cable lock-nut.
I940H1140027-01
5
2
1
5
I940H1140028-03
I940H1140174-01
Advertisement
Chapters
Table of Contents
