Side-Stand Removal And Installation; Specifications; Tightening Torque Specifications; Special Tools And Equipment - Suzuki Intruder VZ1500 Service Manual

Hide thumbs Also See for Intruder VZ1500:
Table of Contents

Advertisement

Side-stand Removal and Installation

Removal
1) Support the motorcycle with the jack or wooden
block.
2) Remove the side-stand as shown in the side-stand
construction. Refer to "Side-stand Construction
(Page 9E-2)".

Tightening Torque Specifications

NOTE
The specified tightening torque is described in the following.
"Body Frame Construction (Page 9E-1)"
"Steering Lock Bracket Construction (Page 9E-2)"
"Side-stand Construction (Page 9E-2)"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Tightening Torque List in Section 0C
(Page 0C-8)".

Recommended Service Material

NOTE
Required service material is also described in the following.
"Body Frame Construction (Page 9E-1)"
"Side-stand Construction (Page 9E-2)"
Installation
B940H29506004
Install the side-stand as shown in the side-stand
construction. Refer to "Side-stand Construction
(Page 9E-2)".

Specifications

Special Tools and Equipment

Body Structure:
9E-3
B940H29507001
B940H29508001

Advertisement

Table of Contents
loading

Table of Contents