Repair Instructions; Heated Oxygen Sensor (Ho2S) Removal And Installation; Heated Oxygen Sensor (Ho2S) Inspection; Pair Reed Valve Removal And Installation - Suzuki Intruder VZ1500 Service Manual

1B-8 Emission Control Devices:
Heated Oxygen Sensor (HO2S) Removal and
Installation
Removal
Refer to "Exhaust Pipe / Muffler Removal and Installation
in Section 1K (Page 1K-2)".
WARNING
!
Do not remove the HO2 sensor while it is hot.
CAUTION
!
• Be careful not to expose the HO2 sensor to
excessive shock.
• Do not use an impact wrench when
removing or installing the HO2 sensor.
• Be careful not to twist or damage the
sensor lead wires.
Installation
Refer to "Exhaust Pipe / Muffler Removal and Installation
in Section 1K (Page 1K-2)".
CAUTION
!
Do not apply oil or other materials to the
sensor air hole.

Heated Oxygen Sensor (HO2S) Inspection

Refer to "DTC "C44" (P0130/P0135): HO2 Sensor
(HO2S) Circuit Malfunction (For E-02, 19, 24, 33) in
Section 1A (Page 1A-80)".

PAIR Reed Valve Removal and Installation

Removal
1) Remove the fuel tank. Refer to "Fuel Tank Removal
and Installation in Section 1G (Page 1G-9)".
2) Remove the air cleaner chamber. Refer to "Air
Cleaner Chamber Removal and Installation in
Section 1D (Page 1D-7)".

Repair Instructions

3) Disconnect the PAIR hoses (1) and remove the PAIR
reed valve covers (2).
B940H21206001
4) Remove the PAIR reed valves (3).
Installation
B940H21206002 Install the PAIR reed valve in the reverse order of
removal. Pay attention to the following points:
• Apply thread lock to the bolts (1) and tighten them.
(THREAD LOCK CEMENT SUPER 1322 or
B940H21206003 equivalent)
1
1
2
3
: Thread lock cement 99000–32110
1
2
I940H1120002-01
3
I940H1120003-01
1
I940H1120004-01