Pair Control Solenoid Valve Removal And Installation; Pair System Inspection - Suzuki Intruder VZ1500 Service Manual

PAIR Control Solenoid Valve Removal and
Installation
Removal
1) Remove the fuel tank. Refer to "Fuel Tank Removal
and Installation in Section 1G (Page 1G-9)".
2) Remove the air cleaner chamber. Refer to "Air
Cleaner Chamber Removal and Installation in
Section 1D (Page 1D-7)".
3) Remove the PAIR control solenoid valve (1).
Installation
Install the PAIR control solenoid valve in the reverse
order of removal. Pay attention to the following points:
• Apply thin coat of the engine oil to the O-ring(-s).
CAUTION
!
Replace the O-ring(-s) with new ones.
• Connect the PAIR control solenoid valve coupler and
PAIR hoses securely. Refer to "PAIR System Hose
Routing Diagram (Page 1B-6)".
B940H21206004
1
I940H1120005-01
I940H1120006-02
Emission Control Devices:

PAIR System Inspection

PAIR Hose
1) Remove the fuel tank. Refer to "Fuel Tank Removal
and Installation in Section 1G (Page 1G-9)".
2) Remove the air cleaner chamber. Refer to "Air
Cleaner Chamber Removal and Installation in
Section 1D (Page 1D-7)".
3) Inspect the PAIR hoses (1) for wear or damage. If it
is worn or damaged, replace the PAIR hose with a
new one. Refer to "PAIR System Hose Routing
Diagram (Page 1B-6)".
1
4) Reinstall the removed parts.
PAIR Reed Valve
NOTE
PAIR control solenoid valve can be checked
without removing it from the motorcycle.
Refer to "DTC "C49" (P1656): PAIR Solenoid
Valve Circuit Malfunction in Section 1A
(Page 1A-86)".
1) Remove the PAIR reed valves. Refer to "PAIR Reed
Valve Removal and Installation (Page 1B-8)".
2) Inspect the reed valves for the carbon deposit.
If the carbon deposit is found in the reed valve,
replace the PAIR reed valve with a new one.
1B-9
B940H21206005
1
I940H1120007-01
I822H1120012-01