Table of Contents
Advertisement
1C-4 Engine Electrical Devices:
ECT Sensor Removal and Installation
Removal
1) Drain engine coolant. Refer to "Cooling System
Inspection in Section 0B (Page 0B-11)".
2) Remove the throttle body. Refer to "Throttle Body
Removal and Installation in Section 1D (Page 1D-
12)".
3) Remove the intake pipes (1).
1
4) Disconnect the water hoses (2).
2
5) Remove the thermostat case (3) along with the water
hose.
B940H21306010
Installation
I940H1130009-01
Install the ECT sensor in the reverse order of removal.
Pay attention to the following points:
• Tighten the ECT sensor (1) to the specified torque.
I940H1130010-02
3
I940H1130011-02
6) Remove the ECT sensor (4).
CAUTION
!
Take special care when handling the ECT
sensor. It may cause damage if it gets an
excessive impact.
CAUTION
!
Use the new gasket washer (2) to prevent
engine coolant leakage.
Tightening torque
ECT sensor (a): 18 N·m (1.8 kgf-m, 13.0 lbf-ft)
2
4
I940H1130012-01
1
(a)
I940H1130013-01
Advertisement
Chapters
Table of Contents
