Ignition Switch Removal And Installation; Specifications; Service Data; Tightening Torque Specifications - Suzuki Intruder VZ1500 Service Manual

1H-10 Ignition System:

Ignition Switch Removal and Installation

Removal
1) Remove the left frame side cover. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-5)".
2) Remove the ignition switch (1).
3) Disconnect the ignition switch lead wire coupler (2).

Service Data

Electrical
Unit: mm (in)
Item
Firing order
Spark plug
Spark performance
CKP sensor resistance
Ignition coil resistance
CKP sensor peak voltage
Ignition coil primary peak voltage

Tightening Torque Specifications

Fastening part
Spark plug
Reference:
For the tightening torque of fastener not specified in this section, refer to "Tightening Torque List in Section 0C
(Page 0C-8)".
B940H21806010
Installation
Install the ignition switch in the reverse order of removal.

Specifications

Specification
1 ⋅ 2
Type
DENSO: U20ESR-N
Gap 0.6 – 0.7 (0.024 – 0.028)
Over 8 (0.3) at 1 atm.
170 – 260 Ω
Primary
Secondary
3.0 V and more
150 V and more
Tightening torque
N⋅m
11
1
NGK: CR6E
1 – 5 Ω
25 – 40 kΩ
kgf-m lbf-ft
1.1 8.0
2
I940H1180015-02
B940H21807001
Note
When cranking
#1: (+) B, (–) Ground
#2: (+) W/Bl, (–) Ground
B940H21807002
Note
(Page 1H-4)