Throttle Body Disassembly And Assembly - Suzuki Intruder VZ1500 Service Manual

• Turn in each throttle cable adjuster fully and locate
each outer cable so that the clearance "a" is 0 – 1.0
mm (0 – 0.04 in).
" a "
"a": 0 – 1.0 mm (0 – 0.04 in)
• Tighten each lock-nut.
• Adjust the throttle cable play. Refer to "Throttle Cable
Play Inspection and Adjustment in Section 0B
(Page 0B-10)".
• Connect the fuel injector couplers (3).
NOTE
Make sure that each coupler installed in the
correct position.
• Connect the clamp.
3
Coupler
Front (#2 Cylinder)
Rear (#1 Cylinder)
" a "
I940H1140030-03
3
I940H1140032-02
Wire color
Y/R and Gr/B
Y/R and Gr/W

Throttle Body Disassembly and Assembly

Refer to "Throttle Body Removal and Installation
(Page 1D-12)".
Disassembly
CAUTION
!
Identify the position of each removed part.
Organize the parts in their respective groups
so that they can be reinstalled in their
original positions.
1) Disconnect the IAP sensor vacuum hoses (1), ISC
valve hoses (2) and fuel feed hose (3).
1
2) Remove the fuel delivery pipes (4).
CAUTION
!
Be careful not to twist the fuel delivery pipe,
when disconnecting the fuel feed hose or
removing the fuel delivery pipe.
Engine Mechanical: 1D-14
B940H21406009
3
2
1
2
I940H1140033-03
4
4
I940H1140034-01