Suzuki Intruder VZ1500 Service Manual page 418

3A-4 Drive Chain / Drive Train / Drive Shaft:
Installation
Install the secondary driven gear assembly in the
reverse order of removal. Pay attention to the following
points:
• When installing the secondary driven gear assembly,
align the pin "A" and hole "B" of the bearing.
"A"
• Apply bond to the each matching surface "C" and "D".
NOTE
• Make surfaces free from moisture, oil, dust
and other foreign materials.
• Spread on surfaces thinly to form an even
layer, and assemble the secondary gear
case few minutes.
• Take extreme care not to apply any bond to
the oil hole, oil groove and bearing.
: Sealant 99000–31110 (SUZUKI BOND
No.1215 or equivalent)
• Install the secondary gear case and temporarily
"B"
I940H1310024-01
• Apply a small quantity of the thread lock to the bearing
"C"
• Tighten the secondary gear bolts to the specified
I940H1310025-03
"D"
I940H1310053-01
tighten the bolts to the specified torque.
Tightening torque
Secondary gear case bolt (Initial) (a): 15 N·m (1.5
kgf-m, 11.0 lbf-ft)
(a)
housing bolts and tighten them to the specified torque.
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
Tightening torque
Secondary driven gear bearing housing bolt (b):
55 N·m (5.5 kgf-m, 40.0 lbf-ft)
(b)
torque.
Tightening torque
Secondary gear case bolt (Final) (c): 26 N·m (2.6
kgf-m, 19.0 lbf-ft)
(c)
I940H1310026-04
(b)
I940H1310027-03
I940H1310028-01