Suzuki Intruder VZ1500 Service Manual page 501

• Check the gearshift cam stopper moves smoothly.
• Locate the gearshift cam in the neutral position.
• Install the gearshift cam stopper plate (6).
NOTE
Align the gearshift cam pin "B" with the
gearshift cam stopper plate hole "C".
6
"C"
• Apply a small quantity of thread lock to the gearshift
cam stopper plate bolt (7) and tighten it to the
specified torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
Gearshift cam stopper plate bolt (c): 10 N·m (1.0
kgf-m, 7.0 lbf-ft)
7
• When installing the gearshift shaft return spring,
position the stopper "D" of the gearshift arm between
shaft return spring ends "E".
"B"
I940H1520058-01
(c)
I940H1520059-01
"E"
"D"
I940H1520060-01
Manual Transmission:
• Apply grease to the lip of the oil seal and install the
gearshift shaft (8).
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
8
• Install the washer (9) and snap ring (10).
NOTE
Pinch the gearshift arm stopper (1) with
return spring ends "F".
9
5B-15
I940H1520061-01
10
I940H1520062-01
"F"
1
"F"
I940H1520063-01