Swingarm Bearing Removal And Installation - Suzuki Intruder VZ1500 Service Manual

2C-11 Rear Suspension:

Swingarm Bearing Removal and Installation

Removal
1) Remove the rear wheel assembly. Refer to "Rear
Wheel Assembly Removal and Installation in Section
2D (Page 2D-10)".
2) Remove the swingarm. Refer to "Cushion Lever
Removal and Installation (Page 2C-7)".
3) Draw out the swingarm pivot bearings (1) using the
special tool.
Special tool
(A): 09921–20240 (Bearing remover set)
4) Remove the center spacer (2).
2
B940H22306013
1
(A)
I940H1230035-01
I940H1230036-01
Installation
1) Install the center spacer.
2) Press the bearings into the swingarm pivot with the
special tool.
NOTE
When installing the bearing, stamped mark
on the bearing must face outside.
Special tool
(A): 09941–34513 (Steering race installer)
3) Apply grease to the bearings.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
4) Install the swingarm. Refer to "Cushion Lever
Removal and Installation (Page 2C-7)".
5) Install the rear wheel assembly. Refer to "Rear
Wheel Assembly Removal and Installation in Section
2D (Page 2D-10)".
(A)
I940H1230037-01
I940H1230040-01