Rear Brake Light Switch Inspection; Rear Brake Light Switch Inspection And Adjustment; Brake Fluid Level Check; Brake Hose Inspection - Suzuki Intruder VZ1500 Service Manual

Hide thumbs Also See for Intruder VZ1500:
Table of Contents

Advertisement

4A-4 Brake Control System and Diagnosis:

Rear Brake Light Switch Inspection

Inspect the rear brake light switch in the following
procedures:
1) Disconnect the rear brake light switch lead coupler
(1).
2) Inspect the switch for continuity with a tester.
If any abnormality is found, replace the rear brake
light switch with a new one.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity (
)
Rear brake light switch
Color
Terminal (O/G)
Position
OFF
ON
3) Connect the rear brake light switch lead coupler.
Rear Brake Light Switch Inspection and
Adjustment
Check the rear brake light switch so that the brake light
will come on just before pressure is felt when the brake
pedal is depressed. If the brake light switch adjustment
is necessary, turn the adjuster nut (1) in or out while
holding the brake pedal.
B940H24106003
1
I940H1410012-01
Terminal (W/B)
I822H1410054-01
B940H24106004
1
I940H1410014-01

Brake Fluid Level Check

Refer to "Brake System Inspection in Section 0B
(Page 0B-14)".

Brake Hose Inspection

Refer to "Brake System Inspection in Section 0B
(Page 0B-14)".

Air Bleeding from Brake Fluid Circuit

Air trapped in the brake fluid circuit acts like a cushion to
absorb a large proportion of the pressure developed by
the master cylinder and thus interferes with the full
braking performance of the brake caliper. The presence
of air is indicated by "sponginess" of the brake lever and
also by lack of braking force. Considering the danger to
which such trapped air exposes the machine and rider, it
is essential that after remounting the brake and restoring
the brake system to the normal condition, the brake fluid
circuit be purged of air in the following manner:
CAUTION
!
Handle brake fluid with care: the fluid reacts
chemically with paint, plastic, rubber
materials, etc.
Front Brake
1) Fill the master cylinder reservoir to the top of the
inspection window. Place the reservoir cap to
prevent dirt from entering.
B940H24106005
B940H24106006
B940H24106007
I940H1410015-02

Advertisement

Table of Contents
loading

Table of Contents