Water Pump Components; Water Pump Removal And Installation - Suzuki Intruder VZ1500 Service Manual

Water pump Components

1. Connector
2. O-ring
3. Water pump case
4. O-ring
5. Impeller assembly

Water Pump Removal and Installation

Removal
NOTE
Before draining engine oil and engine
coolant, inspect engine oil and coolant
leakage between the water pump and
crankcase. If engine oil is leaking, visually
inspect the oil seal and O-ring. If engine
coolant is leaking, visually inspect the
mechanical seal and seal washer. Refer to
"Water Pump Related Parts Inspection
(Page 1F-15)".
1) Drain engine oil and coolant. Refer to "Engine Oil
and Filter Replacement in Section 0B (Page 0B-8)"
and "Cooling System Inspection in Section 0B
(Page 0B-11)".
8
4
3
2
(a)
6. Mechanical seal
7. Oil seal
8. O-ring
: 5.5 N⋅m (0.55 kgf-m, 4.0 Ibf-ft)
: Apply grease.
B940H21606016
Engine Cooling System:
7
6
5
1
(a)
: Apply engine coolant.
: Apply molybdenum oil solution.
: Do not reuse.
2) Remove the left frame lower cover and secondary
gear case cover. Refer to "Exterior Parts Removal
and Installation in Section 9D (Page 9D-5)".
3) Remove the clutch release assembly. Refer to
"Clutch Release Assembly / Push Rod Removal and
Installation in Section 5C (Page 5C-2)".
4) Disconnect the water pump inlet hose (1).
1
1F-11
B940H21606015
I940H1160050-02
I940H1160022-01