Suzuki Intruder VZ1500 Service Manual page 256

1D-67 Engine Mechanical:
• Tighten the crankcase bolts a little at a time to
equalize the pressure.
CAUTION
!
Use the new copper washers and new gasket
washers to prevent oil leakage.
NOTE
Fit the new copper washers "A" and lead wire
"B" to the crankcase bolts.
Tightening torque
Crankcase bolt (M6): 11 N·m (1.1 kgf-m, 8.0 lbf-ft)
Crankcase bolt (M8) (Initial): 15 N·m (1.5 kgf-m,
11.0 lbf-ft)
Crankcase bolt (M8) (Final): 26 N·m (2.6 kgf-m,
19.0 lbf-ft)
"B"
• Check that the driveshaft and countershaft rotate
smoothly.
Oil Separator Plate
Install the oil separator plate (1).
"A"
I940H1140226-01
1
I940H1140227-01
Oil Pressure Switch
Apply bond to the thread part of the oil pressure switch
(1) and tighten the oil pressure switch (1) to the specified
torque.
NOTE
Be careful not to apply bond to the hole of
thread end.
: Sealant 99000–31140 (SUZUKI BOND
No.1207B or equivalent)
Tightening torque
Oil pressure switch (a): 14 N·m (1.4 kgf-m, 10 lbf-ft)
1
(a)
Oil Filter
Install the oil filter with the special tool. Refer to "Engine
Oil and Filter Replacement in Section 0B (Page 0B-8)".
Special tool
(A): 09915–40620 (Oil filter wrench)
I940H1140228-02
(A)
I940H1140229-01