Wheel Dumper Inspection - Suzuki Intruder VZ1500 Service Manual

6) Remove the dumpers with a screw driver.
Installation
Install the wheel damper in the reverse order of removal.
Pay attention to the following points:
• Install the wheel dumpers.
NOTE
If soap water is applied around the dumper, it
makes the job easier.
• Apply grease to the O-ring (1) and the final gear
spline.
CAUTION
!
The removed O-ring must be replaced with a
new one.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
1
Drive Chain / Drive Train / Drive Shaft:
• When install the driven hub joint, align the driven hub
joint flat surface "A" with the screw holes "B" of the
wheel.
I940H1310013-01
• Apply thread lock to the driven hub joint bolts.
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
• Tighten the driven hub joint bolts securely.
• Bend up washers to lock the bolts.
I940H1310014-01

Wheel Dumper Inspection

Inspect the dumpers for wear and damage. Replace the
dumper, if there is anything unusual.
I940H1310015-01
"B" "A"
3A-23
"B"
I940H1310016-01
I940H1310017-01
B940H23106015
I822H1310102-01