Speed Sensor Inspection; Oil Pressure Indicator Inspection - Suzuki Intruder VZ1500 Service Manual

9C-8 Combination Meter / Fuel Meter / Horn:
Installation
Install the speed sensor in the reverse order of removal.
Pay attention to the following points:
• Apply grease to the O-ring.
CAUTION
!
Use a new O-ring to prevent oil leakage.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Tighten the speed sensor (1).
1

Speed Sensor Inspection

Inspect the speed sensor in the following procedures:
1) Remove the speed sensor. Refer to "Speed Sensor
Removal and Installation (Page 9C-7)".
2) Connect a 12 V battery (between B and B/W), 10 kΩ
resistor (between B/R and B) and multi-circuit tester
(tester (+) probe to B and tester (–) probe to B/R) as
shown in the figure.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Voltage ( )
3) Move a screwdriver back and forth across the pick-
up surface of the speed sensor. The voltage
readings should cycle as follows (0 V → 12 V or 12 V
→ 0 V). If the voltage reading does not change,
replace the speed sensor with a new one.
NOTE
While testing, the highest voltage reading
I940H1930020-01
should be the same as the battery voltage (12
V).
I940H1930021-01
B940H29306013

Oil Pressure Indicator Inspection

Inspect the oil pressure indicator in the following
procedures:
NOTE
Before inspecting the oil pressure switch,
check if the engine oil level is correct. Refer
to "Engine Oil and Filter Replacement in
Section 0B (Page 0B-8)".
12 V
10 kΩ
1
1. Speed sensor
I831G1930018-05
I940H1930022-01
B940H29306014