3A-22 Drive Chain / Drive Train / Drive Shaft:
Installation
Install the universal joint in the reverse order of removal.
Pay attention to the following point:
• Before installing the swingarm, install the boot and the
universal joint.
NOTE
Make sure that the "UP" mark "A" on the
boot faces to up.
"A"
Universal Joint Inspection
Inspect the play by turning the universal joint. If
excessive play is noted, replace it with a new one.
CAUTION
!
Do not attempt to disassemble the universal
joint.
Rear Wheel Dumper Removal and Installation
Removal
1) Remove the rear wheel assembly. Refer to "Rear
Wheel Assembly Removal and Installation in Section
2D (Page 2D-10)".
2) Flatten the lock washers.
3) Remove the bolts, washers and plates.
"A"
4) Remove the driven hub joint (1) with the special tool
and wooden block.
I940H1310009-01
Special tool
B940H23106013
5) Remove the O-ring (2).
I940H1310010-01
(A): 09913–50121 (Oil seal remover)
1
B940H23106014
I940H1310011-01
(A)
I940H1310012-01
2
I822H1310095-01