Suzuki Intruder VZ1500 Service Manual page 384

2C-5 Rear Suspension:
• Install the oil seal with the special tool.
CAUTION
!
Replace the oil seal with a new one.
Special tool
(C): 09913–70210 (Bearing installer set)
• Install the cushion rod (2) and cushion lever (3) and
tighten the cushion rod nut to the specified torque.
NOTE
• The stamped marks "A" on the cushion
rod should be face out side.
• The stamped mark "40H" on the cushion
lever should be face right side.
Tightening torque
Cushion rod nut (a): 132 N·m (13.2 kgf-m, 95.5 lbf-
ft)
"A"
(a)
40H 40H 40H 40H 40H 40H 40H
(C)
I940H1230039-01
2
"A"
3
I940H1230011-03
• Install the rear shock absorber (4) and tighten the rear
shock absorber mounting nut to the specified torque.
Tightening torque
Rear shock absorber mounting nut (Lower) (b):
65 N·m (6.5 kgf-m, 47.0 lbf-ft)
(b)
• Install the swingarm assembly and tighten the
swingarm pivot shaft nut (4) to the specified torque
with the special tool.
NOTE
After tightening the swingarm pivot shaft nut,
be sure to check the swingarm operation.
Tightening torque
Swingarm pivot shaft nut (c): 100 N·m (10.0 kgf-
m, 72.5 lbf-ft)
• Tighten the rear shock absorber upper nut to the
specified torque.
Tightening torque
Rear shock absorber mounting nut (Upper) (d):
65 N·m (6.5 kgf-m, 47.0 lbf-ft)
3
I940H1230012-01
4
(c)
I940H1230013-02
(d)
I940H1230014-02