Table of Contents
Advertisement
4) Any leakage from the connecting section should be
corrected by proper tightening. Refer to "Water Hose
Routing Diagram (Page 1F-3)".
5) After finishing the water hose inspection, reinstall the
removed parts.
Water Hose Removal and Installation
Removal
1) Drain engine coolant. Refer to "Cooling System
Inspection in Section 0B (Page 0B-11)".
2) Remove the fuel tank. Refer to "Fuel Tank Removal
and Installation in Section 1G (Page 1G-9)".
3) Remove the left frame head cover.
4) Remove the secondary gear case cover and left
frame lower cover.
5) Remove the left air clearner box.
6) Remove the water hose as shown in the water hose
routing diagram. Refer to "Water Hose Routing
Diagram (Page 1F-3)".
Installation
1) Install the water hose as shown in the water hose
routing diagram. Refer to "Water Hose Routing
Diagram (Page 1F-3)".
2) Pour engine coolant and bleed air from the cooling
circuit. Refer to "Cooling System Inspection in
Section 0B (Page 0B-11)".
3) Reinstall the fuel tank. Refer to "Fuel Tank Removal
and Installation in Section 1G (Page 1G-9)".
Radiator Reservoir Tank Inspection
Inspect the radiator reservoir tank in the following
procedures:
1) Remove the left frame lower cover and secondary
gear case cover. Refer to "Exterior Parts Removal
and Installation in Section 9D (Page 9D-5)".
2) Inspect the radiator reservoir tank cooling leaks. If
any defects are found, replace the radiator reservoir
tank with a new one.
I940H1160009-01
Radiator Reservoir Tank Removal and
Installation
Removal
1) Remove the left frame lower cover and secondary
I940H1160010-01
gear case cover. Refer to "Exterior Parts Removal
and Installation in Section 9D (Page 9D-5)".
2) Remove the reservoir tank bolts.
3) Disconnect the hose (1) and drain the engine
coolant.
B940H21606006
4) Remove the reservoir tank (2).
Engine Cooling System:
B940H21606007
I940H1160011-01
B940H21606008
2
1
I940H1160012-01
1F-7
Advertisement
Chapters
Table of Contents
