Evaporative Emission Control System Inspection (For E-33 Only) - Suzuki Intruder VZ1500 Service Manual

1B-12 Emission Control Devices:
Installation
1) Install the EVAP system purge control solenoid valve
as shown in the EVAP canister hose routing
diagram. Refer to "EVAP Canister Hose Routing
Diagram (Only for E-33) (Page 1B-7)".
2) Tighten the mounting nut to the specified torque.
Tightening torque
EVAP system purge control solenoid valve
mounting nut (a): 7 N·m (0.7 kgf-m, 5.0 lbf-ft)
3) Reinstall the removed parts.
Fuel Shut-off Valve
Removal
1) Move the battery holder (1). Refer to "Battery /
Battery Holder Removal and Installation in Section
1J (Page 1J-11)".
2) Remove the EVAP canister. Refer to "Evaporative
Emission Control System Removal and Installation
(Only for E-33) (Page 1B-11)".
3) Disconnect the surge hoses (2).
4) Remove the fuel shut-off valve (3).
(a)
Installation
1) Install the fuel shut-off valve as shown in the EVAP
canister hose routing diagram. Refer to "EVAP
Canister Hose Routing Diagram (Only for E-33)
(Page 1B-7)".
2) Reinstall the removed parts.
I940H1120016-01
Evaporative Emission Control System
Inspection (For E-33 only)
Refer to "Evaporative Emission Control System Removal
and Installation (Only for E-33) (Page 1B-11)".
Hose
Inspect the hoses for wear or damage. If it is worn or
damage, replace the hose with a new one.
1
NOTE
Make sure that the hoses are securely
connected.
EVAP Canister
Inspect the EVAP canister body for damage to the body.
If any defect is found, replace the EVAP canister with a
new one.
I940H1120013-01
3
2
I940H1120014-04
B940H21206009
I940H1120015-01