Table of Contents
Advertisement
• Degrease the tapered portion "A" of generator rotor
and also the crankshaft "B". Use nonflammable
cleaning solvent to wipe off oily or greasy matter and
make these surfaces completely dry.
• Fit the key (4) in the key slot on the crankshaft.
• Install the generator rotor onto crankshaft.
4
"B"
• Hold the generator rotor and tighten its bolt to the
specified torque.
Tightening torque
Generator rotor bolt (c): 160 N·m (16.0 kgf-m,
115.5 lbf-ft)
• Apply molybdenum oil solution to the idle gear shaft
holes.
M/O: Molybdenum oil (MOLYBDENUM OIL
SOLUTION)
"A"
I940H11A0012-01
(c)
I940H11A0013-01
I940H11A0014-02
• Install the dowel pins and new gasket (5).
CAUTION
!
Use a new gasket to prevent oil leakage.
5
• Install the generator cover and tighten the generator
cover bolts.
WARNING
!
Be careful not to pinch the finger between the
generator cover and the crankcase.
• Install the gearshift lever. Refer to "Gearshift Lever
Removal and Installation in Section 5B (Page 5B-11)".
Charging System:
1J-7
I940H11A0015-01
I940H11A0016-01
Advertisement
Chapters
Table of Contents
