Table of Contents
Advertisement
1D-33 Engine Mechanical:
• Apply molybdenum oil solution to the position rings.
M/O: Molybdenum oil (MOLYBDENUM OIL
SOLUTION)
• Position the piston ring gaps as shown in the figure.
Before inserting each piston into the cylinder, check
that the gaps are properly positioned.
"D"
IN
"B": 2nd ring and lower side rail
"C": Spacer
"D": 1st ring and upper side rail
• Apply bond lightly to the mating surface of crankcase.
: Sealant 99000–31110 (SUZUKI BOND
No.1215 or equivalent)
• Install the dowel pins.
"C"
EX
"B"
I940H1140379-02
I940H1140086-01
I940H1140087-02
Cylinder
• Install the new gaskets (1), front and rear.
CAUTION
!
Use a new gaskets (1) to prevent oil leakage.
• Apply molybdenum oil solution to the sliding surface
of the pistons and cylinder walls.
M/O: Molybdenum oil (MOLYBDENUM OIL
SOLUTION)
• Hold the piston rings in proper positions, and insert
each of the pistons into the respective cylinders.
NOTE
The cylinders can be distinguished by the
embossed-letters, "F" and "R".
1
I940H1140088-01
I940H1140089-01
I940H1140090-01
Advertisement
Chapters
Table of Contents
