Wiring Harness Routing Diagram - Suzuki GSX-R750 Service Manual

9A-3 Wiring Systems:

Wiring Harness Routing Diagram

1. Horn
2. CMP sensor lead wire
3. Cooling fan
4. IAT sensor lead wire
5. Generator lead wire
: Pass the generator lead wire
above the IAT sensor lead wire.
6. Fuel delivery pipe
7. Wiring harness
8. EVAP system purge control
solenoid valve (E-33 only)
9. EXCVA
3
1
2
4
6
5
"E"
16
17
"F"
18
10. Clamp
: Bind the wiring harness, CKP sensor lead wire, rear
brake light switch lead wire, HO2 sensor lead wire and
side-stand switch lead wire with the clamp. Cut off the
excess tip of the clamp.
11. Rear brake light switch lead wire coupler
12. CKP sensor lead wire
13. Fuel pump lead wire
14. Gear position switch lead wire
15. Clamp
: Bind the wiring harness and starter motor lead wire
with the clamp. Cut off excess tip of the clamp.
16. Generator lead wire
17. EXCVA bracket
18. Protector
"A"
"C"
10
"D"
11
5
7
12
13
B838H29102002
"B"
8
10
15
9
14
4
"G"
19
I837H1910901-03
19. IAP sensor
"A": Place the coupler under the PAIR hose.
"B": Secondary fuel injector lead wires are
covered with the tube.
"C": Pass the CKP sensor lead wire under the
clutch cable.
"D": Do not slacken the HO2 sensor lead wire
at this point.
"E": Gray tape
"F": White tape
"G": Prevent the couplers from contacting
strongly to the elbow of the throttle body.