Suzuki Intruder VZ1500 Service Manual page 116

1A-49 Engine General Information and Diagnosis:
P0110-L (Use of SDS)
Step
1 1) Turn the ignition switch OFF.
2) Remove the fuel tank. Refer to "Fuel Tank Removal and
Installation in Section 1G (Page 1G-9)".
3) Check the IAT sensor coupler (1) for loose or poor
contacts.
If OK, then check the IAT sensor lead wire continuity.
4) Disconnect the IAT sensor coupler.
5) Check the continuity between the Dg wire and ground. If
the sound is not heard from the tester, the circuit
condition is OK.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity (
6) Connect the IAT sensor coupler.
7) Turn the ignition switch ON.
8) Insert the needle pointed probes to the lead wire coupler.
Action
1
)
Yes
Go to Step 2.
I940H1110035-01
(A)
I822H1110043-01
No
• Dg wire shorted to
ground.
• If wire is OK, go to
Step 2.