Engine Coolant Temperature Indicator Light Inspection; Engine Coolant Temperature Removal And Installation - Suzuki Intruder VZ1500 Service Manual

3) Disconnect the pilot lamp lead wire coupler (2).
2
4) Remove the pilot lamp (3) from the fuel tank cover
(1).
3
Installation
Install the pilot lamp in the reverse order of removal.
Engine Coolant Temperature Indicator Light
Inspection
Inspect the engine coolant temperature indicator light in
the following procedures:
1) Remove the right air cleaner box. Refer to "Air
Cleaner Element Removal and Installation in Section
1D (Page 1D-6)".
2) Disconnect the ECT sensor coupler (1).
1
3) Connect the variable resistor (2) between the
terminals.
I940H1930012-01
4) Turn the ignition switch ON.
5) Check the LED operations when the resistance is
adjusted to the specified values.
If either one or all indications are abnormal, replace
1
the combination meter with a new one. Refer to
"Combination Meter Removal and Installation
(Page 9C-2)".
Resistance
0.11 kΩ and over
0.11 kΩ and below
I940H1930013-01
B940H29306006
6) Connect the ECT sensor coupler.
Engine Coolant Temperature Removal and
Installation
Refer to "ECT Sensor Removal and Installation in
Section 1C (Page 1C-4)".
I940H1930014-01
Combination Meter / Fuel Meter / Horn:
2
LED (3)
OFF
ON
3
9C-5
I718H1930009-05
Water temperature
120 °C below
120 °C and over
I940H1930015-02
B940H29306007