Front Wheel Dust Seal / Bearing Removal And Installation - Suzuki Intruder VZ1500 Service Manual

2D-6 Wheels and Tires:
Wheel
1) Remove the brake pads. Refer to "Front Brake Pad
Replacement in Section 4B (Page 4B-2)".
2) Make sure that the wheel runout checked as shown
does not exceed the service limit. An excessive
runout is usually due to worn or loosened wheel
bearings and can be reduced by replacing the
bearings. If bearing replacement fails to reduce the
runout, replace the wheel.
3) Install the brake pads. Refer to "Front Brake Pad
Replacement in Section 4B (Page 4B-2)".
Wheel rim runout
Service limit (Axial and Radial): 2.0 mm (0.08 in)
Wheel Bearing
Inspect the play of the wheel bearings by finger while
they are in the wheel. Rotate the inner race by finger to
inspect for abnormal noise and smooth rotation. Replace
the bearing in the following procedure if there is anything
unusual. Refer to "Front Wheel Dust Seal / Bearing
Removal and Installation (Page 2D-6)".
Front Wheel Dust Seal / Bearing Removal and
Installation
Removal
1) Remove the front wheel assembly. Refer to "Front
Wheel Assembly Removal and Installation
(Page 2D-3)".
2) Remove the dust seals (1).
Special tool
3) Remove the bearings (2) using the special tool.
I649G1240014-02
Special tool
4) Remove the spacer (3).
I649G1240015-02
(A): 09913–50121 (Oil seal remover)
(A)
1
(B): 09921–20240 (Bearing remover set)
3
B940H22406005
I940H1240015-02
(B)
2
I940H1240016-01
I940H1240017-01