Suzuki Intruder VZ1500 Service Manual page 270

1D-81 Engine Mechanical:
2) Place the thrust washer, camshaft drive sprocket and
primary drive gear on the right end of the crankshaft
and tighten primary drive gear bolt (2) to the
specified torque. Refer to "Primary Drive Gear
Removal and Installation in Section 5C (Page 5C-
13)".
Tightening torque
Primary drive gear bolt (a): 150 N·m (15.0 kgf-m,
108.5 lbf-ft)
3) Measure the thrust clearance by using the thickness
gauge. If the thrust clearance exceeds the standard
range, adjust the thrust clearance.
Selection
1) Remove the thrust bearing and measure its thickness using the micrometer. If the thickness of the thrust bearing is
below standard, replace it with a new one and once again perform the thrust clearance measurement listed above.
Special tool
(A): 09900–20205 (Micrometer (0 – 25 mm))
(B): 09900–20702 (Micrometer stand)
Special tool
Crankshaft thrust clearance
Standard: 0.100 – 0.150 mm (0.0039 – 0.0059 in)
2
(a)
I940H1140288-01
NOTE
Pull the crankshaft to the right (Primary
driven gear side) so that there is no
clearance on the thrust bearing.
(A): 09900–20803 (Thickness gauge)
(A)
(A)
(B)
I940H1140290-02
I940H1140289-01