Suzuki Intruder VZ1500 Service Manual page 429

8) Remove the bearing stopper with the special tool.
Special tool
(C): 09924–62410 (Final drive gear bearing
holder wrench)
9) Remove the final drive bevel gear (8) and shims (9).
8
10) Remove the bearing with the inner race from the
final drive bevel gear with the special tool.
Special tool
(D): 09913–60910 (Bearing remover)
NOTE
If no abnormal noise, the bearing removal is
not necessary.
11) Remove the washer (10).
10
(C)
I822H1310053-03
9
I822H1310054-02
(D)
I822H1310055-01
Drive Chain / Drive Train / Drive Shaft:
12) Remove the inner race with the special tool.
Special tool
(D): 09913–60910 (Bearing remover)
CAUTION
!
When replacing the drive bevel gear, replace
the driven bevel gear also, as they must be
replaced together.
13) Remove the final gear case bolts.
14) Remove the final gear bearing case (11) from the
final gear case by using two 5 mm screws.
3A-15
(D)
I822H1310056-01
I822H1310057-01
11
I822H1310058-01