Suzuki Intruder VZ1500 Service Manual page 530

6B-5 Steering / Handlebar:
6) Remove the wire harness, brake hose and each
cables. Refer to "Wiring Harness Routing Diagram in
Section 9A (Page 9A-5)", "Front Brake Hose Routing
Diagram in Section 4A (Page 4A-1)" and "Throttle
Cable Routing Diagram in Section 1D (Page 1D-2)".
7) Remove the handlebars. Refer to "Handlebars
Removal and Installation (Page 6B-1)".
8) Remove the headlight housing brace (1).
1
9) Remove the front forks. Refer to "Front Fork
Removal and Installation in Section 2B (Page 2B-2)".
10) Remove the steering stem upper bracket (2).
11) Remove the steering stem nut using the special tool.
NOTE
When loosening the stem nuts, hold the
steering stem lower bracket to prevent it from
falling.
Special tool
(A): 09940–14911 (Steering stem nut
wrench)
12) Remove the steering stem lower bracket.
13) Remove the dust seal (3) and steering stem upper
I940H1620010-01
2
14) Remove the handlebar holders (5), holder rubbers
I940H1620011-01
bearing (4).
3
(6) and rubber seats (7).
5
7
6
(A)
I940H1620012-01
4
I940H1620013-01
7
6
I940H1620014-01