Front Wheel Related Parts Inspection; Front Wheel Dust Seal / Bearing Removal And Installation - Suzuki 2005 GSF1200 Service Manual

2D-6 Wheels and Tires:

Front Wheel Related Parts Inspection

Refer to "Front Wheel Assembly Removal and
Installation: "
Tire
Refer to "Tire Inspection: in Section 0B".
Front Brake Disc
Refer to "Front Brake Disc Inspection: in Section 4B".
Dust Seal
Inspect the dust seal lips for wear or damage. If any
defects are found, replace the dust seal with the new
ones. Refer to "Rear Wheel Dust Seal / Bearing /
Removal and Installation: ".
Axle Shaft
Using a dial gauge, check the axle shaft for runout. If the
runout exceeds the limit, replace the axle shaft.
Special tool
(A): 09900–20607 (Dial gauge (1/100mm,
10mm))
(B): 09900–20701 (Magnetic stand)
(C): 09900–21304 (V-block (100mm))
Axle shaft runout
Service limit: 0.25 mm (0.010 in)
(A)
(C)
Wheel
Make sure that the wheel runout checked as shown
does not exceed the service limit. An excessive runout is
usually due to worn or loosened wheel bearings and can
be reduced by replacing the bearings. If bearing
replacement fails to reduce the runout, replace the
wheel.
Wheel runout
B649G12406019
Service limit (Axial and Radial): 2.0 mm (0.08 in)
Wheel Bearing
Inspect the play of the wheel bearings by finger while
they are in the wheel. Rotate the inner race by finger to
inspect for abnormal noise and smooth rotation. Replace
the bearing in the following procedure if there is anything
unusual. Refer to "Front Wheel Dust Seal / Bearing
Removal and Installation: ".
I649G1240013-01
Front Wheel Dust Seal / Bearing Removal and
Installation
Removal
1) Remove the front wheel assembly. Refer to "Front
2) Remove the dust seals (1), left and right.
(B)
I649G1240054-01
Wheel Assembly Removal and Installation: ".
Special tool
(A): 09913–50121 (Oil seal remover)
1
I649G1240014-01
I649G1240015-01
B649G12406020
(A)
I649G1240016-02