Front Wheel Speed Sensor Rotor Removal And Installation (Gsx1300Bkak8) - Suzuki GSX1300BKA Supplementary Service Manual

4E-11 ABS:
• Tighten the front footrest bracket mounting bolts to the
specified torque. Refer to "Front Footrest Bracket
Construction in Section 9E in related manual".
Tightening torque
Front footrest bracket mounting bolt (a): 23 N·m (
2.3 kgf-m, 16.5 lb-ft)
• Check the clearance between the rear wheel speed
sensor and sensor rotor using the thickness gauge.
Special tool
(A): 09900–20803 (Thickness gauge)
(B): 09900–20806 (Thickness gauge)
Wheel speed sensor – Sensor rotor clearance
0.3 – 1.5 mm (0.012 – 0.059 in)
(A),(B)
Front Wheel Speed Sensor Rotor Removal and
Installation (GSX1300BKAK8)
CAUTION
!
• The ABS is made up of many precision
parts; never subject it to strong impacts or
allow it to become dirty or dusty.
• Do not hit the front wheel speed sensor
rotor when dismounting the front wheel.
Removal
1) Remove the front wheel assembly. Refer to "Front
2) Remove the front wheel speed sensor rotor (1).
(a)
I823H3410003-01
Installation
Install the front wheel speed sensor rotor in the reverse
order of removal. Pay attention to the following points:
• Install the front wheel speed sensor rotor as the letters
"50T" face outside.
I823H3450015-01
• Install the front wheel assembly. Refer to "Front Wheel
B823H34506006
Assembly Removal and Installation
(GSX1300BKAK8) in Section 2D (Page 2D-3)".
Wheel Assembly Removal and Installation in Section
2D in related manual".
CAUTION
!
When replacing the tire, make sure not to
damage the sensor rotor.
1
I823H3450062-01
50T
I823H3450063-01