Side Stand/Ignition Interlock System Parts Inspection - Suzuki TU250X Service Manual

SIDE STAND/IGNITION INTERLOCK SYSTEM
PARTS INSPECTION
Check the interlock system for proper operation. If the interlock
system does not operate properly, check each component for
damage or abnormalities. If any abnormality is found, replace
the component with a new one.
SIDE-STAND SWITCH
• Disconnect the side-stand switch coupler 1.
• Measure the voltage between G and B/W lead wires.
 09900-25008: Multi circuit tester set
 Tester knob indication: Diode test ()
ON
(Side-stand up)
OFF
(Side-stand down)
NOTE:
If the tester reads 1.4 V and below when the tester probes are
not connected, replace its battery.
NEUTRAL SWITCH
• Remove the front seat. (8-3)
• Disconnect the neutral switch coupler 1 and check the conti-
nuity between Bl and B/W with the transmission in "NEU-
TRAL".
 09900-25008: Multi circuit tester set
 Tester knob indication: Continuity test ()
ON (Neutral)
OFF (Except neutral)

When disconnecting and connecting the neutral
switch coupler, make sure to turn OFF the ignition
switch, or electronic parts may get damaged.
G B/W
(+ Probe) (- Probe)
0.4 – 0.6 V
1.4 V and more
(Tester's battery voltage)
Bl B/W
ELECTRICAL SYSTEM 9-19