Swingarm Related Parts Inspection - Suzuki GSF650A Service Manual

• Tighten the cushion lever, cushion rod and rear shock
absorber mounting nut to the specified torque.
Tightening torque
Cushion rod mounting nut (b): 78 N·m (7.8 kgf-m,
56.5 lbf-ft)
Cushion lever mounting nut (c): 78 N·m (7.8 kgf-
m, 56.5 lbf-ft)
Rear shock absorber mounting nut (d): 50 N·m (
5.0 kgf-m, 36.0 lbf-ft)
(c)
(b)
(b)

Swingarm Related Parts Inspection

Refer to "Swingarm / Cushion Rod Removal and
Installation (Page 2C-8)".
Spacers
1) Remove the spacers from the swingarm.
2) Inspect the spacers for wear and damage. If any
defects are found, replace the spacers with new
ones.
(d)
I717H1230028-01
(d)
I717H1230029-01
B817H22306012
I717H1230030-01
Chain Buffer
Inspect the chain buffer for wear and damage. If any
defect is found, replace the chain buffer with a new one.
Swingarm Bearing and Cushion Rod Bearing
1) Insert the spacers into bearings.
2) Check the play by moving the spacers up and down.
If excessive play is noted, replace the bearing with a
new one. Refer to "Swingarm Bearing Removal and
Installation (Page 2C-11)".
Swingarm
Inspect the swingarm for damage. If any defect is found,
replace the swingarm with a new one.
Rear Suspension: 2C-10
I717H1230031-01
I717H1230032-01
I717H1230033-01