Ignition Switch Removal And Installation - Suzuki GSX-R750 Service Manual

1H-11 Ignition System:

Ignition Switch Removal and Installation

Removal
1) Remove the air cleaner box. Refer to "Air Cleaner
Box Removal and Installation in Section 1D
(Page 1D-7)".
2) Disconnect the ignition switch lead wire coupler (1).
3) Disconnect the immobilizer lead wire coupler (2).
(For E-02, 19, 24)
2
4) Remove the harness clamp (3).
5) Remove the ignition switch (4) with the special tools.
Special tool
(A): 09930–11920 (Torx bit (JT40H))
(B): 09930–11940 (Bit holder)
(A)
(B)
B838H21806008
1
I837H1180013-01
3
I837H1180018-01
4
I837H1180019-01
Installation
Install the ignition switch in the reverse order of removal.
Pay attention to the following points:
• Tighten the ignition switch mounting bolts (1), right
and left with the special tools.
CAUTION
!
When reusing the ignition switch bolts, clean
the threaded part and apply a thread lock to
them.
Special tool
(A): 09930–11920 (Torx bit (JT40H))
(B): 09930–11940 (Bit holder)
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
(A)
(B)
1
I837H1180020-01