Table of Contents
Advertisement
Chapter 3 Setup
2.
System BIOS Setup
This section describes how to configure Basic Input Output System (BIOS).
2.1
Overview
The BIOS Setup Utility (SETUP) is a utility to configure basic hardware settings. This utility is pre-installed in
the server as standard and can run without bootable discs.
Usually, you do not need to change the parameters of the SETUP. Use only when the case applies to any
of cases described in Chapter 3 (2.4 Cases that Require Setting Changes).
2.2
Starting SETUP Utility
Turn on the server and wait until the following message appears. See Chapter 3 (1.1.1 POST sequence) for
details.
Press <F2> SETUP, <F3> Internal Flash Memory, <F4> ROM Utility, <F12> Network
When you press <F2> key during displaying the message or the NEC logo, SETUP runs and displays the
Main menu upon completion of POST.
About password entry
The entry of the password appears after you set a password in SETUP.
Enter password [
If you enter a wrong password three times, SETUP stops. Turn off the server and try again.
To exit SETUP after saving the parameters, choose Save & Exit and then Save Changes and Exit.
To exit SETUP without saving the parameters, choose Save & Exit and then Discard Changes and Exit.
120
]
Express5800/T110g-E User's Guide
2. System BIOS Setup
Advertisement
Table of Contents
