System Data Entry; Cat - NEC NEAX2000 IVS2 Installation Manual

SYSTEM DATA ENTRY

There are two methods for data entry, using a Customer Administration
Terminal (CAT) or a Maintenance Administration Terminal (MAT).
NOTE: For assigning system data, refer to the Command Manual.

CAT

term
Any D can be assigned as a CAT through programming. The D
regular telephone when it is not in CAT mode. If the system is initialized by "C" (Resident System
term
Program), every D
Clear), only LEN000 is assigned as a CAT port (the DLC card must be installed in slot LT00).
term
To use a D as a CAT, follow the procedures shown below.
NOTE: It is necessary to complete Steps 1 through 6 within four seconds.
To set CAT mode:
TRF
1. Press
CNF
2. Press
- CNF/Conf lamp flashes
3. Press *
- CNF/Conf lamp is off
TRF
4. Press
CNF
5. Press
- CNF/Conf lamp flashes
#
6. Press
- CNF/Conf, SPKR/Speaker, FNC/Feature lamps are lit
- "CAT MODE" is displayed on the LCD
LNR/SPD
7. Press
- "COMMAND = -" is displayed on the LCD
2
NEAX2000 IVS Installation Procedure Manual
ND-70928 (E), Issue 3.0
will be able to go into CAT mode. If the system is initialized by "B" (All
Transfer
or
Conf
or
Transfer
or
Conf
or
Redial
or
CHAPTER 2 INSTALLATION
System Data Entry
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
term
can still be used as a
Page 219