Enable Interface; Eif: Enable Interface - 3Com CoreBuilder 9000 User Manual

Enable Interface

Enable interface module port. You are prompted to specify a port.
Command Actions
Enter the menu sequence: (1) SYS: Platform Configuration
Enter a parameter at the prompt
Parameter
Port ID
Port State
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 5 2 1.1.2
The following message is displayed:
Setting port state command has completed successfully.
Port 2 of the selected ATM Interface Module is enabled.
Configuring Interface Modules
(5) IFC: Interface Cards

(2) EIF: Enable Interface

Format or Range
<slot.group.port>
0 - disable
1 - enable
1 5 2 [parameters]
The selected port on the interface module is enabled.
Setting port state command has
completed successfully.
105