Omron G5 Series User Manual page 411

Display of the Number of I/O Signal Changes
Number of I/O signal changes
Pin No.
... Input signal
... Output signal
Press
Reserved
Do not set.
Reserved
Do not set.
Monitor for the Number of Encoder Communications Errors
Number of communications error
... Encoder
Press
OMNUC G5-series (Pulse-train Input Type) AC Servomotors and Servo Drives User's Manual
It is possible to change the pin number if the decimal
point is located on the right of the pin number.
to move the flashing decimal point.
It is possible to switch input and output, if the decimal
point is located between the pin number.
Press to switch input and output.
... Reserved
to switch "Encoder" or "Reserved".
8 Operation
8
8 - 15