Renault Laguna III Manual page 3312

Upper body: General description
B91 or K91
Note:
The information contained in the following
describes the general repair procedure for all vehi-
cles having the same design for this part.
Before reading the following general information,
make sure that there are no special notes associ-
ated with the vehicle. These special notes are spec-
ified if necessary in other parts of the sub-section
dealing with the component.
Note:
For a detailed description of a particular connec-
tion, see MR 400.
I - DESIGN OF THE STRUCTURAL COMPONENT
This is a basic part; its only function is that of an upper
body.
SIDE UPPER STRUCTURE
115656
II - AREA TO BE CUT FOR PARTIAL
REPLACEMENT
III - ASSEMBLY METHOD FOR A PARTIAL
REPLACEMENT
Only the connections which are specific to the partial
replacement by cutting are indicated.
WARNING
If the mating faces of the parts to be welded are not
accessible, make EGW plug welds to replace the
original resistance welds (see MR 400).
If there are other issues regarding access to mating
faces, the various replacement options are described
in the basic instructions for structural bodywork repair
(see MR 400).
43A-26
43A
101427