Renault Laguna III Manual page 3343

Outer rear wheel arch: General description
B91 or D91 or K91
Note:
The information contained in the following
describes the general repair procedure for all vehi-
cles having the same design for this part.
Before reading the following general information,
make sure that there are no special notes associ-
ated with the vehicle. These special notes are spec-
ified if necessary in other parts of the sub-section
dealing with the component.
Note:
For a detailed description of a particular connec-
tion, see MR 400.
I - DESIGN OF THE STRUCTURAL COMPONENT
The special feature of this part is its extension from the
quarter panel lining to create the external rear wheel
arch.
REAR UPPER STRUCTURE
105282
II - AREA TO BE CUT FOR PARTIAL
REPLACEMENT
The line (1) in the drawing shows the area in which it is
possible to carry out a partial replacement.
III - ASSEMBLY METHOD FOR A PARTIAL
REPLACEMENT
Only the connections which are specific to the partial
replacement by cutting are indicated.
WARNING
If the mating faces of the parts to be welded are not
accessible, make EGW plug welds to replace the
original resistance welds (see MR 400).
If there are other issues regarding access to mating
faces, the various replacement options are described
in the basic instructions for structural bodywork repair
(see MR 400).
44A-23
44A
105635