Pic Mac Addresses; Tx Matrix Interface Names Overview; Scc And Lcc Interfaces - Juniper TX MATRIX Hardware Manual

PIC MAC Addresses

TX Matrix Interface Names Overview

SCC and LCC Interfaces

Copyright © 2010, Juniper Networks, Inc.
lcclcc-number-re1
lcc-number identifies the T640 router and can be from 0 through 3. For example, to
configure Routing Engine 1 properties for
hierarchy level.
lcc3-re1]
You must include the
apply-groups
including and .
re0 re1
Providing special group names for all Routing Engines in the routing matrix allows you
to configure the individual Routing Engines in each T640 router differently. Parameters
that are not configured at the
routing matrix.
For more information about configuring the TX Matrix router, see"Performing the Initial
Software Configuration for the TX Matrix Router" on page 142 and the Junos OS
configuration guides.
When you integrate a T640 router into a routing matrix, the PIC media access control
(MAC) addresses for the T640 router are derived from a pool of MAC addresses
maintained by the TX Matrix router. This means the PIC MAC addresses used in the
formerly standalone T640 router are changed after the T640 router is integrated into a
routing matrix. To determine the newly assigned MAC address for an interface on a PIC
in an integrated T640 router, issue the
SCC and LCC Interfaces on page 147
FPC Interfaces on page 148
In certain statements and commands in the CLI, you refer to the TX Matrix chassis as
and to a T640 chassis as
lcc
by including statements at the
levels, where lcc-number is the chassis identifier (ID) of the T640 router.
Operational commands that reference chassis hardware components—such as SIBs,
FPCs, and PICs—require you to specify either
example, to display a list of all hardware components in T640
command as follows:
chassis hardware
user@host> show chassis hardware lcc 2
lcc2-re0:
--------------------------------------------------------------------------
Hardware inventory:
Item Version
Chassis
Midplane REV 03
FPM GBUS REV 09
FPM Display REV 05
CIP REV 06
, you include statements at the
lcc3
statement in the configuration for all special groups,
hierarchy level apply to all Routing Engines in the
groups
show interfaces interface-name
. You can configure the TX Matrix chassis and T640 chassis
and
[edit chassis] [edit chassis lcc lcc-number]
or , followed by the chassis ID. For
scc lcc
Part number Serial number
65745
710-005608 RA1400
710-002901 RA3317
710-002897 RA3249
710-002895 HS0716
Chapter 17: Configuring Junos OS
[edit groups
command.
scc
hierarchy
2 ( lcc 2 ), issue the show
Description
T640
T640 Backplane
T640 FPM Board
FPM Display
T-series CIP
147