Configuring Snmp Trusted Managers - AudioCodes Mediant 800B User Manual

Note: Only row entries whose corresponding check boxes are selected are applied
when clicking Submit; otherwise, settings revert to their defaults.
Table 8-2: SNMP Trap Destinations Parameters Description
Parameter
Web: SNMP Manager
[SNMPManagerIsUsed_x]
Web: IP Address
[SNMPManagerTableIP_x]
Trap Port
[SNMPManagerTrapPort_x]
Web: Trap User
[SNMPManagerTrapUser]
Trap Enable
[SNMPManagerTrapSendingEnable_x]
8.3

Configuring SNMP Trusted Managers

The SNMP Trusted Managers table lets you configure up to five SNMP Trusted Managers
based on IP addresses. By default, the SNMP agent accepts SNMP Get and Set requests
from any IP address as long as the correct community string is used in the request.
Security can be enhanced by using Trusted Managers, which is an IP address from which
the SNMP agent accepts and processes SNMP requests.
The following procedure describes how to configure SNMP trusted managers in the Web
interface. You
SNMPTrustedMgr_x or CLI command, configure system > snmp > trusted-managers.
User's Manual
Enables the SNMP Manager to receive traps and checks
the validity of the configured destination (IP address and
port number).

[0] (check box cleared) = (Default) Disables SNMP
Manager

[1] (check box selected) = Enables SNMP Manager
Defines the IP address (in dotted-decimal notation, e.g.,
108.10.1.255) of the remote host used as the SNMP
Manager. The device sends SNMP traps to this IP
address.
Defines the port number of the remote SNMP Manager.
The device sends SNMP traps to this port.
The valid value range is 100 to 4000. The default is 162.
Associates a trap user with the trap destination. This
determines the trap format, authentication level, and
encryption level.

v2cParams (default) = SNMPv2 user community string

SNMPv3 user configured in ''Configuring SNMP V3
Users'' on page
Activates the sending of traps to the SNMP Manager.

[0] Disable

[1] Enable (Default)
can also configure
84
Mediant 800B Gateway and E-SBC
Description
86
this using the table
Document #: LTRT-10620
ini file parameter,