Parameter
bandIndex]
Start Time
CLI: start-time
[CostGroupTimebands_StartT
ime]
End Time
CLI: end-time
[CostGroupTimebands_EndTi
me]
Connection Cost
CLI: connection-cost
[CostGroupTimebands_Conn
ectionCost]
Minute Cost
CLI: minute-cost
[CostGroupTimebands_Minut
eCost]
15.4.2.4 Assigning Cost Groups to Routing Rules
To use your configured Cost Groups, you need to assign them to routing rules:
Gateway application: Outbound IP Routing table - see Configuring Outbound IP
Routing Table on page
SBC application: IP-to-IP Routing table - see Configuring SBC IP-to-IP Routing Rules
on page
User's Manual
Defines the day and time of day from when this time band is
applicable. The format is DDD:hh:mm, where:
DDD is the day of the week, represented by the first three letters
of the day in upper case (i.e., SUN, MON, TUE, WED, THU,
FRI, or SAT).
hh and mm denote the time of day, where hh is the hour (00-23)
and mm the minutes (00-59)
For example, SAT:22:00 denotes Saturday at 10 pm.
Defines the day and time of day until when this time band is
applicable. For a description of the valid values, see the parameter
above.
Defines the call connection cost during this time band. This is
added as a fixed charge to the call.
The valid value range is 0-65533. The default is 0.
Note: The entered value must be a whole number (i.e., not a
decimal).
Defines the call cost per minute charge during this timeband.
The valid value range is 0-65533. The default is 0.
Note: The entered value must be a whole number (i.e., not a
decimal).
369
515
Mediant 800B Gateway and E-SBC
Description
220
Document #: LTRT-10278