Setting Lldp Operating Mode - H3C S5120-EI Series Operation Manual

To do...
Enter system view
Enable LLDP globally
Enter
Ethernet
interface
view/port
group view
Enable LLDP
To make LLDP take effect, you need to enable it both globally and on the related ports.

Setting LLDP Operating Mode

Follow these steps to set LLDP operating mode:
To do...
Enter system view
Set the initialization delay
period
Enter
Ethernet
interface
view/port
group view
Set the LLDP operating mode
Use the command...
system-view
lldp enable
Enter Ethernet interface interface-type
interface view
interface-number
Enter port port-group manual
group view port-group-name
lldp enable
Use the command...
system-view
lldp timer reinit-delay value
Enter Ethernet interface interface-type
interface view interface-number
Enter port port-group manual
group view port-group-name
lldp admin-status { disable |
rx | tx | txrx }
—
Required
By default, LLDP is enabled globally.
Either of the two is required.
Configuration performed in Ethernet
interface view applies to the current
port only; configuration performed in
port group view applies to all the
ports in the corresponding port
group.
Optional
By default, LLDP is enabled on a
port.
—
Optional
2 seconds by default.
Either of the two is required.
Configuration performed in
Ethernet interface view applies
to the current port only;
configuration performed in port
group view applies to all the
ports in the corresponding port
group.
Optional
TxRx by default.
1-5
Remarks
Remarks