2BT
(3) Adjustment after roller and clutch replacement
Perform the following adjustment after refitting rollers and clutches.
(3-1) Adjusting the leading edge registration of image printing
Make the following adjustment if there is a regular error between the leading edges of the copy image and original.
U066
U034
(P. 1-6-24)
Caution:
Check the copy image after the adjustment. If the image is still incorrect, perform the above adjustments in maintenance
mode.
Procedure
Enter maintenance mode.
Enter "034" using the copy exposure
adjustment keys or zoom +/- keys.
Press the start key.
Select the items to be adjusted using
the copy exposure adjustment keys.
Exp. 1 (lit): Leading edge registration
from the drawer
Exp. 3 (lit): Leading edge registration
from the bypass tray
Press the size select key and the
machine enters the test copy mode.
Press the start key
to output a test pattern.
Is the leading edge
registration correct?
Press the stop/reset key to exit
maintenance mode.
1-6-8
Start
No
Yes
Setting range: –9.9 – +9.9
Initial setting: 0
Changing the value by 1 moves the
leading edge by 1.0 mm.
End
Leading edge registration
Correct image
Output
example 1
Figure 1-6-13
Press the start key
The new setting is stored
For output example 1, decrease
the value using the zoom (–)
key.
For output example 2, increase
the value using the zoom (+)
key.
Output
example 2