Printing The Menu Map; Using The Menu Selection System; Printing Status Page - Kyocera Mita FS-9500DN Operation Manual

2.2 Using the Menu Selection System

This section explains the procedure for using the menu selection
system. The menu selection system is activated by the MENU
key while the printer is Ready.

2.2.1 Printing the Menu Map

The printer prints a full list of menu selection system. Note that
menus indicated on the list may vary depending on which option
units are installed on the printer.
1
Press the MENU key.
2 Press the 3 or 4 key repeatedly until Print Menu
Map appears.
Print
Menu Map
3
Press the ENTER key. A question mark (?) appears.
Print
Menu Map ?
4
Press the ENTER key again. The printer prints a menu
map.
Chapter 3 Using the Operator Panel

2.2.2 Printing Status Page

If you want to check the printer's current status, including mem-
ory available and option settings, you can find the information
you need on the status page.
1
Press the MENU key.
2
Press the 3 or 4 key repeatedly until Print Status
Page appears.
Print
Status Page
3
Press the ENTER key. A question mark (?) appears.
Print
Status Page
4
Press the ENTER key again. The printer prints a status
page.
NOTE
For a full description of the status, see the following sample sta-
tus page.
The following is a sample status page. The numbers below refer
to the contents explained on the next page.
2
4
6
When the Network Status is turned on, the Network Interface
Status Page will be outputted after the Printer Status. (See
3-20.)
?
1
3
5
7
8
9
0
A
page
3-10