Input Switching & Pip Menu - Christie DWU8902-GS User Manual

Input Switching & PIP menu
The Input Switching & PIP menu determines how the main and PIP/PBP inputs are handled.
Input Switching & PIP
1. Main Input
2. PIP/PBP Input
3. PIP/PBP Enable
4. Swap
5. Size
6. Main Layout
7. Timing Detection Mode
8. Source Info
9. Input Key
10. Blank on Signal Switch
Menu item Description
Main Input Selects an active input to be used as the main
image.
PIP/PBP Input Selects an active input to be used as the PIP/
PBP.
PIP/PBP Enable Toggles between displaying two sources at
once (main and PIP/PBP images) or one
source only.
Refer to
compatibility
Swap Changes the main image to PIP/PBP, and the
PIP/PBP to main image.
Swapping is available only when PIP/PBP is
enabled.
Size Selects the PIP/PBP size to small, medium, or
large.
Main Layout Sets the location of the PIP/PBP image on the
screen.
Timing Detection Sets timing detection mode to wide or normal
Mode to support additional PC timings. When the
projected picture is not completed, this
function is used to adjust the picture.
For 4:3 input sources not recognized by Wide
mode (for example 1400 x 1050), perform
Auto Image using Normal mode.
Source Info Displays the current source settings. (Read-
only)
Input key Lists or changes the sources.
GS Series DWU8902-GS User Manual
020-001795-01 Rev. 1 (04-2020)
Copyright ©2020 Christie Digital Systems USA Inc. All rights reserved.
VGA
HDMI1
Medium
Top Right
Auto Source
Inputs on page 51 and PIP/PBP
on page 55.
Options
—
—
• Selected checkbox—Turns the PIP/PBP
source on
.
• Cleared checkbox—Turns the PIP/PBP source
off.
—
—
—
• Normal mode—Supports 4:3 input sources.
• Wide mode—Supports the 16:9 input source
and most 4:3 input sources.
—
—
Operation
42