Main Input; Input Switching & Pip Menu - Christie J Series User Manual

3.10 Input Switching & PIP Menu
Use the Input Switching & PIP menu to
enable and define how you want to use PIP.
NOTE: To control the primary image, access
all picture controls through the Main menu.
To control the secondary (PIP) image, access
picture controls through the Input Switching
& Picture-in-Picture menu.

MAIN INPUT

From the list of active inputs, select one to be
used as the primary or main image.
PIP INPUT
From the list of active inputs, select one to be used as the secondary or PIP.
SWAP MAIN & PIP INPUTS
Toggle the current PIP relationship so that the primary (main) image becomes secondary (PIP), and the
secondary image becomes primary. Swapping is available only when PIP is enabled.
experience a slight delay when swapping the Primary and Secondary images.
PIP ENABLE
Short cut: Press PIP on the Remote if menu not
present.
Toggle between displaying two sources at once
(Main and PIP images) and the primary or main
source only. This check box turns the secondary
source on and off.
PIP WINDOWS OPTIONS - Submenu
• PIP POSITION PRESETS
Select a preset location and size of the PIP window. While in split screen mode, several channel controls that
resize image will be disabled. These controls are size, H-Position and V-Position.
• PIP WINDOW SIZE
Sets the width of the PIP window in pixels. The active portion of the input signal, as determined by blanking
controls, will be scaled to fit into the PIP window. The height of the PIP window will be set to maintain the
aspect ratio of the image being captured, as determined by the Vertical Stretch control.
• PIP H-POSITION
Sets the center position of the Picture-In-Picture window on the screen.
• PIP V-POSITION
Sets the center position of the Picture-In-Picture window on the screen.
J Series 1000W and 1200W User Manual
020-100706-02 Rev. 1 (03-2014)
Input Switching & PIP
1. Main Input
2.
PIP Input
3. Swap Main and PIP Inputs
4. PIP Enable
5. PIP Window Options
6. PIP Size & Position
7. PIP Image Settings
8. Fade Time
9.
Frame Locking
10. Auto Input Searching
11.
HDMI Output Loop Source
12. Standby Active Loop-Through
F 3-39 I
IGURE
Primary Image
Adjust through
Main menu
navigation.
Section 3: Operation
Twin HDMI Input Card, Slot 4 Input 1
Twin HDMI Input Card, Slot 4 Input 1
Off
0.20
Frame Lock
Main/Secondary Loop
S & PIP
NPUT WITCHING
NOTE: You may
Secondary
(PIP) Image
Adjust through
PIP menu.
3-53