Input Switching & Pip Menu - Christie D12HD-H User Manual

4.6 Input Switching & PIP Menu
1. Main Input
2. PIP/POP Input
3. PIP/POP Enable
4. Swap
5. Size
6. Main Layout
7. Timing Detection Mode
8. Source Info
9. Input key
10. Blank on Signal Switch
Main Input
From the list of active inputs, select one to be used as the main image.
PIP/POP Input
From the list of active inputs, select one to be used as the PIP/PBP.
PIP/POP Enable
Toggle between displaying two sources at once (Main and PIP/PBP images) or
one source only. The checkbox turns the PIP/PBP source ON and OFF. Refer
to Section 6.2 for the Main and PIP/PBP compatibility table.
Swap
Change the main image to PIP/PBP, and the PIP/PBP to main image.
Swapping is available only when PIP/PBP is enabled.
Size
Select the PIP/PBP size to small, medium or large.
Main Layout
Set the location of the PIP/PBP image on the screen.
H Series User Manual
020-000772-02 Rev.1 (08-2015)
Input Switching & PIP
Section 4: OPERATION
VGA
Card reader
Medium
Top Right
Auto Source
4-18